Brand an iced matcha cup using either a specified print reference or a label reviewed for the actual surface and application workflow. Condensation is a condition to document, not a guaranteed label rating.
Separate direct cup print from an applied label
Direct printing and an applied label use different production and handling processes. Record quantity per cup size and artwork, then ask what each quote includes. A label also needs its own construction, usable placement area and application review.
| Workflow | Confirm |
|---|---|
| Printed cup | Exact cup, print areas, artwork and quantities |
| Cup plus label | Cup surface, label construction, placement and assembly |
| Shared brand label | Approved design plus any separate recipe identification |
Record when the label is applied
Identify whether the cup is labeled before filling, after filling or after exposure to a cold environment. Describe surface moisture and handling. Request the proposed label’s application instructions for that sequence; a result on a dry empty cup does not establish performance after condensation.
Avery identifies moisture as an obstacle to adhesive contact in its application guidance. The specific construction and instructions for your proposed label still need confirmation.
Check placement on the actual cup curve
Measure the intended area and note taper, ribs or textured surfaces. Use a placement mockup to check wrinkles and readability around the curve. Keep the label clear of the rim, intended grip and closure path. A flat rectangular artwork file does not prove finished fit.
Compare one change at a time
- Record cup and label sample identifiers.
- Use the same recipe and handling sequence for comparisons.
- Observe edge lifting, appearance and print readability.
- Record elapsed time and conditions, without generalizing a limited trial.
Use the surface specification and the cost calculator to compare entered quantities and measured application work.
BrandYourPack planning worksheet. Sample checks described here are steps for your project, not published test results. Confirm material, dimensions, print, quantities and intended use for the proposed reference before approval.
Questions about this decision
Are ordinary stickers suitable for an iced cup?
Suitability is not established by the word sticker. Review the surface, construction and moisture/application conditions of the exact proposed reference.
Should I label the cup before or after filling?
Use the approved workflow for the proposed construction and your operation. Record both workflows separately if you are comparing them.
Does a successful dry-cup trial cover condensation?
No. The observation applies to the recorded conditions; review the intended iced-drink sequence as well.
