Measure the container with its lid fitted, then record the sleeve path, taper, flange and opening method. Use those observations to request a final structural drawing.
Measure the closed container at the intended sleeve path
Identify the exact container and lid reference. Mark where the sleeve should sit. Measure around that path using a flexible trial strip, noting changes in width or height and any lid flange. State units and whether the measurements are outside dimensions.
| Field | What it resolves |
|---|---|
| Container and lid code | Which assembled reference is being measured |
| Sleeve path | Where the band sits on the completed pack |
| Perimeter at that path | Starting fit information |
| Taper and corners | Why a straight band may not sit evenly |
| Lid flange and tabs | Clearance and opening access |
| Desired band width | Visible area and coverage |
Choose an assembly method before adding allowances
Describe whether staff slide on a pre-formed band or wrap and secure it. Record where the seam should sit and how the customer removes it. The fabricator determines joining allowance and manufacturing tolerances for the proposed construction; do not add an arbitrary universal overlap.
Try the strip on the filled, closed pack
Use the normal assembled container, not an empty body without its lid. Observe sliding, rocking, closure interference and readability. Photograph the top, sides and seam. This mockup communicates geometry only; it is not a production dieline or a material-performance test.
Prepare the structural request and an available alternative
Send the measurements, photos, intended conditions, assembly method and quantity per design for sourcing review. A dedicated sleeve reference is not confirmed here. If using labels instead, prepare a usable-surface brief; a label needs a different dimensional and adhesive review.
BrandYourPack planning worksheet. Sample checks described here are steps for your project, not published test results. Confirm material, dimensions, print, quantities and intended use for the proposed reference before approval.
Questions about this decision
Can I use only the container length and width?
Those dimensions omit the sleeve path, taper, lid flange and assembly method. Measure the assembled pack around the intended band position.
How much overlap should I add?
Ask the fabricator for the allowance required by the proposed seam and material. This guide does not define a universal overlap.
Can a paper trial confirm chilled performance?
No. It communicates fit. The proposed construction and real use conditions need a separate sample review.
